LaCrosse FWD V6-3.0L (2010)
17. The EN-48313 - tool is now properly installed to hold the timing chain in position.
18. Use an open end wrench on the hex cast into the camshaft in order to prevent engine rotation when loosening the camshaft position actuator bolt.
19. Remove the left exhaust camshaft position actuator bolt.
20. Remove the left exhaust camshaft position actuator. When removing the actuator, place the chain on the engine cover side of the actuators.
21. Rotate the actuator in order to align the opening in the actuator reluctor wheel with the cam sensor boss in the front cover, to allow actuator
removal.
22. Remove the camshaft thrust washer.
23. If removing both the exhaust and intake camshaft actuators, the timing chain can be draped over the EN-48313 - tool once the actuators have been
removed.
Installation Procedure