LaCrosse FWD V6-3.0L (2010)
Caution: Do not pry against the face of the camshaft position actuators or the position actuator retaining bolts as the position actuators will be
damaged.
25. Position a screwdriver or small pry bar between a camshaft cap and camshaft lobe. Carefully move/pry the camshafts as far as possible toward the
rear/flywheel end of the engine.
Note: Do not move or disturb the EN49982 - retainer components after their installation or the timing chains may be lost inside the front cover.
26. The EN49982-1 - retainer and EN49982-2 - retainer should be in position as shown, they must be left in position during the servicing of the
camshaft position actuator(s) and/or camshaft(s).