LaCrosse FWD V6-3.0L (2010)
17. The EN-48313 - tool is now properly installed to hold the timing chain in position.
18. Use an open end wrench on the hex cast into the camshaft in order to prevent engine rotation when loosening the camshaft position actuator bolt.
19. If replacing the exhaust camshaft position actuator, then remove the bolt and the actuator.
20. If replacing the Intake camshaft position actuator, then remove the bolt and the actuator.
21. If removing both the exhaust and intake camshaft actuators, the timing chain can be draped over the EN-48313 - tool once the actuators have been
removed.
22. Rotate the actuator in order to align the opening in the actuator reluctor wheel with the cam sensor boss in the front cover, to allow actuator
removal.
23. Remove the camshaft thrust washer.
Installation Procedure