LeSabre V6-181 3.0L (1986)
REAR DOOR
2.
Insert scalp molding into beltline opening at the front of the door frame but DO NOT snap or slide onto the black scalp molding clip. (Figure 1)
3 and 4.
Position front door window frame scalp molding assembly to
front door. Starting at the upper rear corner, engage over outer edges of the top leg and upper rear vertical leg of the door frame
simultaneously. (Figure 3). Once corner on frame, push scalp molding as far forward as possible on horizontal leg of header.
5-9.
Engage molding over the outer edge of the stationary door frame
and snap molding onto retainer clips on the inner edge of stationary door frame (Figure 2) working in the order depicted in Figure 3.
10.
Engage molding over the INNER edge of the black clip then snap over the OUTER edge.
11 and 12.
Engage molding over the outer edge of the stationary door
frame and snap molding onto retainer clips on the inner edge of stationary door frame (Figure 2) working in the order depicted in Figure 3.
IMPORTANT:
Cross section of correctly installed molding (Figure 4).
Kent-Moore Installation Tool No. J-38714 will be available May 1, 1990
