LeSabre V6-181 3.0L (1986)
6.
Disconnect jumper wire from pin H (green wire).
Add foam insulation as necessary to ensure rattle-free installation of the afterblow module under dash or in the front console area.
NOTICE:
The afterblow module is not compatible with some non-factory installed theft alarm systems. The module current draw at key off
could trigger alarms that sense battery voltage changes or current drain.
For warranty purposes use Labor Operation T6235 for 1.9 hours on Electra/Park Avenue and Reatta/Riviera or 1.7 hours on Skyhawk and Skylark
vehicles. If debris needs to be removed from the heater/evaporator case and the air inlet screen needs to sealed, use an add time of .2 hour.
