LeSabre V6-181 3.0L (1986)
condition. If an acceptable finish surface cannot be obtained, contact Kent-Moore Automotive Division for assistance.
On-Vehicle Rotor
The recommended procedure for refinishing brake rotors is through the use of on-vehicle rotor turning equipment (Kent-Moore J 37704). This method is
particularly effective because it can compensate for stacked tolerances that cause rotor/bearing system runout and help prevent a return of the condition.
On-vehicle rotor turning equipment is available through Kent-Moore, Part Number J 37704. Full setup and operating instructions are provided with the
equipment. Contact Kent-Moore for ordering information.
We believe this source and their equipment to be reliable. There may be additional manufacturers of such equipment. General Motors does not endorse,
indicate any preference for, or assume any responsibility for product equipment from these firms, or for any such items which may be available from
other sources.
Lateral Runout Check
A lateral runout check is an integral part of the on-car refinishing procedure. If off-vehicle rotor refinishing is used, the following lateral runout check
should be performed:
1.
Remove wheel, invert wheel nuts and reinstall them on the studs. Tighten nuts to 20 lbs.ft. following the tightening sequetice shown in Figure 1.
2.
Fasten a dial indicator to the caliper so that the indicator button contacts the rotor approximately 13 mm (0.500 in.) from the outer edge.
3.
Zero the dial indicator needle.
4.
Rotate the rotor one complete revolution while observing runout indicated on the dial. Total indicated runout (T.I.R.) should not exceed 0.08 mm
(0.003 in.).
On front wheel drive vehicles, lateral rotor runout due to stacked tolerances can often be reduced by rotating (indexing) the rotor one or two bolt
holes in relation to the hub. If excessive runout cannot be corrected by indexing the rotor, check the hub and bearing assembly for looseness.
NOTICE:
Whenever the brake rotor has been separated from the wheel bearing flange, clean any rust or foreign material from the mating surfaces of the
wheel bearing flange and rotor. Failure to do this may result in increased lateral runout of the rotor and brake pulsation.
5.
If lateral rotor runout exceeds the amount specified in Step 4, refinish the rotor on the vehicle.
Rotor Thickness Variation Check
Variations in rotor thickness can be checked by measuring the thickness of the rotor at four or more points around the surface of the rotor. Use a
micrometer calibrated in one tenth increments per .001 in. All measuring points must be the same distance in from the edge of the rotor.
A rotor that varies in thickness by more than 0.013 mm (0.0005 in.) can cause pedal pulsation and/or front end vibration during brake applications.
Rotors with 0.013 mm or higher thickness variations should be refinished or replaced as necessary.
