LeSabre V6-181 3.0L (1986)
Starter Solenoid: Testing and Inspection
FREE SPEED TEST
Refer to ``Delco-Remy Starters'' for Free Speed Test.
PINION CLEARANCE CHECK
1.
Disconnect field coil connector from solenoid terminal and insulate carefully.
2.
Connect one 12 volt battery lead to solenoid switch terminal and other lead to starter motor frame.
3.
Flash a jumper lead momentarily from solenoid motor terminal to starter motor frame. This will shift pinion into cranking position until battery is
disconnected.
4.
Push pinion back as far as possible to take up any movement, then check pinion clearance using a feeler gauge. Pinion clearance should be
.020---.080 inch. If clearance is not within limits, check for improper installation or worn parts and replace as necessary. Clearance may be
adjusted by adding or removing shims located between the switch and front bracket. Adding shims decreases amount of movement. Shims are
available in thicknesses of .010 and .020 inch.
