LeSabre V6-231 3.8L VIN L SFI (1992)
WIRING PROCEDURE:
1.
Cut circuit 439 (pnk/blk) wire far enough from the relay connector to allow for splicing. Strip the relay side of the wire for splicing. Tape back the
harness side of circuit 439. Refer to Figure 1 for wiring modification schematic.
2.
Cut circuit 5 (yellow wire) far enough from the relay connector to allow for splicing.
3.
Splice the three wires (both circuit 5 wires and the circuit 439 wire to the relay) together with a splice clip, part number 1839906, which can be
found in terminal repair kit tool J 38125-A. Follow the procedure for "splicing copper wire using splice clips" in the service manual.
Parts are currently available from GMSPO.
WARRANTY INFORMATION:
Replacing the starter enable relay
Labor Operation No.:
J4645
Labor Time:
.4 hr. (Riviera/Reatta)
1.5 hr. (LeSabre/Park Avenue/Ultra)
