LeSabre V6-231 3.8L VIN L SFI (1992)
-
Remove case side cover bolts and side cover from transaxle.
-
Disconnect solenoid harness as needed.
NOTE: It is not necessary to remove the pump or valve body to remove or replace the transaxle solenoids. Solenoids are retained in the valve body by
spring clips. Be careful when removing the TCC solenoid and shift solenoid "A", as there is a valve and spring in the same bore with each of
these solenoids.
Transaxle Solenoid And Retainer Clip Locations (valve Body Shown W/Pump Removed) 4T60-E
-
Remove the spring clip retaining the solenoid(s) to be removed and carefully work the solenoid out of its bore.
Reverse procedure to install. Always use new gaskets and tighten case side cover bolts to 9 - 13Nm (80 - 115 lb.in.)
