LeSabre V6-3.8L VIN K (1996)
Accessory Delay Module: Initial Inspection and Diagnostic Overview
Troubleshooting Hints
1. Check RH I/P Power Distribution Center Fuse 2 by visual inspection.
2. Check I/P Fuse Block WPR/WSHR Fuse 8E by visual inspection.
3. Check Engine Compartment MaxiFuse(R) Block RH "IGN1" Fuse by visual inspection.
-
Check for a broken (or partially broken) wire inside of the insulation which could cause system malfunction but prove "GOOD" in a
continuity/voltage check with a system disconnected. These circuits may be intermittent or resistive when loaded, and if possible, should be
checked by monitoring for a voltage drop with the system operational (under load).
-
Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems.
-
Refer to System Diagnosis.
