Lucerne V6-3.8L (2007)
16.
When programming is complete:
16.1. Turn off Tech2.
16.2. Turn the ignition switch to the OFF position.
17.
Wait 30 seconds~.
18.
Turn the ignition switch to the ON position with engine OFF.
19.
Turn on the Tech 2.
20.
Build the vehicle using the Tech 2.
21.
Using the Tech 2, navigate to Vehicle Control Systems / Module Setup / Remote Control Door Lock Receiver.
22.
Run the Copy and Paste TPM Information Procedure (F1: Step 2).
23.
Using the Tech 2, navigate to Vehicle Control Systems / Module ID Information / Remote Control Door Lock Receiver / Tire Information.
24.
Verify that the four Pressure Sensor IDs match those that were recorded in Step 5.
25.
Go into diagnostics and check for DTC codes.
26.
Clear all codes.
Programming Remote Keyless Entry Transmitters (Vehicles in Inventory)
Important:
All of the transmitters that are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single
programming sequence. Once the Invalidate All Fobs selection is made or the RCDLR module has been reprogrammed, all learned
transmitters are erased. Up to 8 transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles
that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle.
Program remote keyless entry transmitters.
1.
With a scan tool, access the Remote Control Door Lock Receiver Module Setup menu. Select Program Key Fobs.
2.
Select Next Available Slot. Follow the on-screen instructions. Simultaneously hold the LOCK and UNLOCK buttons on the keyless entry
transmitter to program.
3.
When all the desired transmitters have been programmed, exit the vehicle and operate the transmitter functions in order to verify correct system
operation.
Programming Remote Keyless Entry Transmitters (Sold Vehicles)
Important:
Make several copies of the programming instructions if required.
Some customers may not bring all of their remote keyless entry transmitters to your dealership for programming. Vehicles are sold with two
transmitters. However, customers have the option to purchase additional transmitters. Ensure that customers understand that all of the transmitters
that are to be recognized by the remote control door lock receiver (RCDLR) must be programmed at one time in order to function properly.
Program the transmitters that the customer provides to you using a scan tool. Inform the customer that all of the remaining transmitters will not
function properly until they are programmed. Customers must program all of their transmitters, including the transmitters programmed at your
dealership, at one time, using the driver information center (DIC) programming method. Inform customers to locate and program their transmitters
using the procedure provided. This procedure is also published in the owner manual.
