Lucerne V6-3.8L (2007)
1. Install the power steering pressure hose (3) to the vehicle.
Notice: Refer to Fastener Notice.
2. Install the power steering pressure hose banjo bolt (1) with 2 NEW washers (2).
Tighten the power steering pressure hose banjo bolt 55 N.m (41 lb ft).
3. Install the power steering pressure hose to the power steering gear.
Tighten the power steering pressure hose to the power steering gear to 30 N.m (22 lb ft).
4. Install the power steering hose retainer (2) to the engine frame.
5. Install the power steering pressure hose into the power steering hose retainer.
6. Install the power steering gear heat shield.
7. Lower the vehicle.
8. Bleed the power steering system.
