Lucerne V6-3.8L VIN 2 (2006)
23. Remove the J35589-A from the brake master cylinder reservoir.
24. Fill the brake master cylinder reservoir to the maximum-fill level with Delco Supreme 11(R), GM P/N 12377967 (Canadian P/N 992667), or
equivalent DOT-3 brake fluid from a clean, sealed brake fluid container.
25. Slowly depress and release the brake pedal. Observe the feel of the brake pedal.
26. Important: If it is determined that air was induced into the system upstream of the ABS modulator prior to servicing, the ABS Automated Bleed
Procedure must be performed.
If the brake pedal feels spongy, perform the following steps:
1. Inspect the brake system for external leaks. Refer to Brake System External Leak Inspection. See: Hydraulic System/Testing and
Inspection/Component Tests and General Diagnostics/Brake System External Leak Inspection
2. Using a scan tool, perform the antilock brake system automated bleeding procedure to remove any air that may have been trapped in the
BPMV. Refer to ABS Automated Bleed Procedure.
27. Turn the ignition key ON, with the engine OFF. Check to see if the brake system warning lamp remains illuminated.
28. Important: DO NOT allow the vehicle to be driven until it is diagnosed and repaired.
If the brake system warning lamp remains illuminated, refer to Symptoms - Hydraulic Brakes. See: Hydraulic System/Testing and
Inspection/Symptom Related Diagnostic Procedures
