Lucerne V6-3.8L VIN 2 (2006)
5. Remove the rear exhaust hanger to hanger bracket nut. (single exhaust shown, dual exhaust similar).
6. Apply a suitable lubricant to the rear hanger rod in order to ease the removal of the hanger.
7. Pull outward on the rear exhaust hanger in order to remove it from the tail pipe hanger rod.
Installation Procedure
1. Apply a soapy solution to the rear hanger rod and the inner diameter of the rear exhaust hanger in order to ease the installation of the hanger.
2. Press the rear exhaust hanger over the tail pipe hanger rod.
3. Position the rear exhaust hanger to the rear exhaust hanger bracket. (single exhaust shown, dual exhaust similar).
4. Notice: Refer to Fastener Notice.
Install the rear exhaust hanger to hanger bracket nut.
Tighten the nut to 30 Nm (22 ft. lbs.).
5. Apply a soapy solution to the exhaust pipe hanger rod and the inner diameter of the center exhaust hanger in order to ease the installation of the
hanger.
6. Press the exhaust hanger over the exhaust pipe hanger rod.