Lucerne V6-3.9L (2009)
Body / Frame Mount Bushing: Service and Repair
Forward Body Mount Replacement
Forward Body Mount Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the exhaust system. Refer to Exhaust System Replacement (See: Engine, Cooling and Exhaust/Exhaust System/Service and Repair).
3. Support the forward end of the rear suspension support assembly with a jack stand.
4. Remove the brackets from the body at the support assembly forward mounts.
5. Remove the two bolts securing the front of the support assembly to the body of the vehicle.
6. Lower the front end of the support assembly enough for the forward mount (1) removal.
7. Bend the tabs (1) on the inboard mount (2) and tap the mount downward and out of the support assembly.
Installation Procedure
1. Tap the mount into the support assembly, ensuring that the flat is outboard (2) and the notch (1) is rearward upon installation.
2. Bend the tabs outboard with a large pair of channel lock pliers.
3. Raise the support assembly to the body of the vehicle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
