Lucerne V6-3.9L (2009)
Reprogram the object alarm module with the latest software calibration.
Important
Select the correct calibration files for the appropriate vehicle configuration (body style) and RPO codes.
A revised calibration and software have been developed to address this condition. Technicians are to reprogram the object alarm module using the
Service Programming System (SPS) with the latest software available on TIS2WEB. Refer to the Object Alarm Module Programming and Setup in SI.
When using a Tech 2(R) or a Multiple Diagnostic Interface (MDI) for reprogramming, ensure that it is updated with the latest software version.
During programming, the battery voltage must be maintained within the proper range of 12-15 volts. Only use the approved Midtronics(R) PSC 550
Battery Maintainer (SPS Programming Support Tool EL-49642) or equivalent during programming.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer
