Lucerne V6-3.9L (2009)
4. Raise the lower control arm and install the shock absorber retaining bolts in the lower control arm.
Tighten the lower shock absorber retaining bolts to 25 Nm (18 lb ft).
5. Attach the rear brake caliper to the bracket using the caliper guide pin bolts.
Tighten the caliper guide pin bolts to 34 Nm (25 lb in).
6. Install the stabilizer link. Refer to Stabilizer Shaft Link Replacement (See: Stabilizer Bar/Stabilizer Link/Service and Repair/Rear Suspension).
7. Install the adjustment link to the control arm.
Tighten adjustment link retaining nut to 30 Nm (22 lb ft) plus 180 degrees.
8. Connect the automatic level control sensor link to the control arm.
9. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair).
10. Lower the vehicle.
