Park Avenue V6-3.8L SC VIN 1 (2005)
Headlamp Bulb: Service and Repair
HEADLAMP BULB REPLACEMENT
REMOVAL PROCEDURE
CAUTION: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To
help avoid personal injury:
-
Turn off the lamp switch and allow the bulb to cool before changing the bulb.
-
Leave the lamp switch OFF until the bulb change is complete.
-
Always wear eye protection when changing a halogen bulb.
-
Handle the bulb only by its base. Avoid touching the glass.
-
Keep dirt and moisture off the bulb.
-
Properly dispose of the used bulb.
-
Keep halogen bulbs out of the reach of children.
1. Remove the headlamp.
2. Remove the inoperative headlamp bulb (3 or 4) from the headlamp assembly (1).
3. Disconnect the bulb from the wire harness.
INSTALLATION PROCEDURE
1. Install the wire harness to the headlamp bulb.
NOTE: Avoid touching the bulb or letting the bulb come in contact with anything damp. Oil from your skin or moisture on the bulb can cause the
bulb to explode when the bulb is turned on. If either comes in contact with the bulb, clean the bulb with alcohol or a suitable degreaser and wipe the
bulb dry.
2. Install the headlamp bulb (3 or 4) into the headlamp assembly (1).
3. Install the headlamp assembly.
