Park Avenue V6-3.8L SC VIN 1 (2005)
Evaporative Emissions Hose: Service and Repair
Evaporative Emission (EVAP) Hoses/Pipes Replacement - Canister/Fuel Tank
EVAPORATIVE EMISSION (EVAP) HOSES/PIPES REPLACEMENT - CANISTER/FUEL TANK
REMOVAL PROCEDURE
NOTE:
-
Do not attempt to straighten kinked nylon pipes. Replace any kinked nylon pipes in order to prevent damage to the vehicle.
-
Do not attempt to repair sections of nylon pipes. Replace damaged nylon pipes.
-
Replace the vapor pipes with original equipment or parts that meet GM specifications.
-
Replace the vapor hoses with original equipment or parts meeting GM specifications. Use only reinforced fuel-resistant hose identified with the
word Fluoroelastomer or GM 6163M on the hose.
1. Remove the fuel tank (5).
2. Disconnect the evaporative emission (EVAP) vent hose/pipe (1) from the fill limiter vent valve.
3. Remove the EVAP vent hose/pipe from the fuel tank (5).
INSTALLATION PROCEDURE
1. Position the EVAP vent hose/pipe (1) on the fuel tank (5).
2. Connect the EVAP vent hose/pipe (1) to the fuel limiter vent valve.
3. Install the fuel tank.
4. Lower the vehicle.
