Park Avenue V6-3.8L SC VIN 1 (2005)
5. Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the
ON position.
Connect the EBCM electrical connector (1) to the EBCM (4).
6. Rotate the EBCM connector tab (2) down to the locked position.
7. Install the EBCM connector position assurance (2) to the EBCM electrical connector (1).
8. Install the left front fascia extension.
9. Install the left front wheel.
10. Lower the vehicle.
11. Important: An unprogrammed EBCM will result in the following conditions:
^
Inoperative or poorly functioning Dynamic Rear Proportioning (DRP)/ABS/Traction Control System (TCS)/Vehicle Stability Enhancement
System (VSES)/TIM/Variable Effort Steering (VES) if equipped
^
Set DTC C1248 EBCM Turned the Red Brake Warning Indicator On
^
Set DTC C1255m3 EBCM Internal Malfunction
If a replacement EBCM is being installed, it must be programmed using the latest software matching the vehicle. Refer to the Techline
Terminal/Equipment user's instructions.
12. Use the scan tool in order to clear the DTCs.
13. Fill and bleed the hydraulic brake system.
14. Perform the auto bleed procedure.
15. Perform the ABS Diagnostic System Check. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check -
Vehicle
