Park Avenue V6-3.8L SC VIN 1 (2005)
Control Module HVAC: Service and Repair
BLOWER MOTOR CONTROL PROCESSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the right sound insulator.
2. Remove the instrument panel (I/P) storage compartment.
3. Remove the I/P fuse/relay center.
4. Disconnect the blower motor control processor electrical connector.
5. Remove the blower control processor retaining screws.
6. Remove the blower control processor (1).
INSTALLATION PROCEDURE
1. Install the blower motor control processor (1).
2. Install the screws.
Tighten the screws to 2 N.m (23 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the blower motor control processor electrical connector.
4. Install the I/P fuse/relay center.
5. Install the I/P storage compartment.
6. Install the right sound insulator.
