Park Avenue V6-3.8L SC VIN 1 (2005)
4. Install the SDM mounting fasteners (2).
Tighten the fasteners to 9 N.m (80 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
5. Connect both wiring harness connectors (3) to the SDM (2).
6. Install both wiring harness connectors (3) from the CPA (1) to the SDM.
7. Install the carpet into the vehicle.
8. Install the front passenger seat.
9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9.
10. Program the new SDM into the body control module (BCM). See: Testing and Inspection/Programming and Relearning
IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to
be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps
thoroughly to ensure that the SDM is set properly.
