Park Avenue V6-3.8L VIN K (1995)
Air Door Actuator / Motor: Service and Repair
Manual Electronic Controls
A/C Temperature Valve Actuator
REMOVE OR DISCONNECT
1. Right sound insulator.
2. Instrument Panel (I/P) compartment, (glove box).
3. Temperature valve link rod from temperature valve (snap out).
4. Electrical connector from A/C temperature valve actuator.
5. Securing screws and A/C temperature valve actuator.
INSTALL OR CONNECT
1. A/C temperature valve actuator and securing screws.
-
Tighten screws to 1.4 Nm (12 lb. in.).
2. Electrical connector to A/C temperature valve actuator.
Note: Adjust valve link rod before connecting to temperature valve.
Temperature Valve Link Adjustment
-
Start vehicle; set fan to IIII (HIGH) and temperature to full hot.
-
Allow 45 seconds minimum for A/C temperature valve actuator to move to full hot position. Move temperature valve to full hot position and
snap temperature valve link rod into temperature valve.
3. Temperature valve link rod to temperature valve (snap in).
4. I/P compartment insert.
5. Right sound insulator.