Park Avenue V6-3.8L VIN K (1995)
Heater Core: Service and Repair
Automatic Control (RPO C68, CJ2)
HEATER CORE (RPO C68 or CJ2) Removal and Installation
TOOL REQUIRED
J 37097 Mubea Hose Clamp Pliers (or equivalent)
REMOVE OR DISCONNECT
1. Drain cooling system.
Heater Hoses
2. Heater hoses from heater core, using J 37097.
3. Programmer. See: Control Module HVAC/Service and Repair
4. Retaining screws and heater core cover.
5. Retaining screws and heater core from vehicle.
INSTALL OR CONNECT
1. Heater core into vehicle and attaching screws.
Tighten
^
Screws to 1.4 Nm (12 lb in)
2. Heater core cover and attaching screws.
Tighten
^
Screws to 1.4 Nm (12 lb in)
3. Programmer. See: Control Module HVAC/Service and Repair
