Park Avenue V6-3.8L VIN K (1995)
Cabin Temperature Sensor / Switch: Service and Repair
In-Vehicle Temperature Sensor
REMOVE OR DISCONNECT
1. Instrument Panel (I/P) lower trim plates (snap out).
2. Air deflectors (snap out).
3. I/P accessory trim plate retaining screws and plate.
4. Aspirator hose and sensor assembly.
-
Disengage snap tabs.
5. In-vehicle temperature sensor.
-
Disengage from aspirator hose.
6. Electrical connector.
INSTALL OR CONNECT
1. Electrical connector.
2. In-vehicle temperature sensor to aspirator hose.
3. Aspirator hose and sensor assembly to I/P.
-
Make sure hose routing is not crimped or bent when installing.
4. I/P accessory trim plate and retaining screws.
-
Tighten screws to 1.9 Nm (17 lb. in.).
5. Air deflectors (snap in).
6. Instrument Panel lower trim plates (snap in).