Rainier 2WD V8-5.3L VIN P (2004)
10.5. Secure the old optic cable together with the new one (E).
Important:
The optic cable must not be bent with a radius less than 25 mm (1 in).
Important:
Secure the wiring harness so that there is no risk of chafing and rattling.
11.
CV: Remove the rear seat in accordance with WIS - 8. Body - Interior equipment - Adjustment/Replacement. The O-bus connector H2-9 is located
behind the left speaker.
12.
M04-05: Disconnect the optic cables on the OnStar(R) control modules and join the cables:
12.1. Cut off the cable tie holding the connector (H2-9) against REC.
12.2. Cars with brackets for e.g. an amplifier: Remove the pin strap (A) from the bracket and remove the tape (B) holding the optic cables.