Rainier 2WD V8-5.3L VIN P (2004)
Seat Cushion: Service and Repair
Seat Cushion Frame Replacement - Front
Seat Cushion Frame Replacement - Front
Removal Procedure
1. Remove the 3 seat switch bezel mounting screws.
2. Remove the 4 nuts that secure the seat pan to the power seat adjuster frame.
3. Remove the clip from the front outboard seat pan stud, if equipped. Discard the clip.
4. Disconnect the black electrical connector (6) from the seat back harness.
5. Disconnect the black electrical connector (3) from the seat belt buckle.
6. Disconnect the gray lumbar electrical connector (5), if equipped.
7. Remove the SIR harness (2) from the harness clips (1, 4), and remove the SIR harness from the seat.
8. Remove the seat harness from the seat pan.
9. Remove the seat memory module, if equipped.
10. Remove the seat cushion assembly.
11. Remove the seat cushion cover and pad from the seat frame.
12. Remove the wiring harness and connector clips, if you are replacing the frame.
Installation Procedure
1. Install the wiring harness and connector clips, if you replaced the frame.
2. Install the seat memory module, if equipped.
3. Install the seat cushion cover and pad to the seat frame.
