Rainier 2WD V8-5.3L VIN P (2004)
Air Door Actuator / Motor: Service and Repair
Recirculation Actuator Replacement
RECIRCULATION ACTUATOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the HVAC module assembly.
2. Remove the air inlet assembly.
3. Remove the screws from the air inlet assembly.
4. Remove the recirculation actuator screws.
5. Remove the recirculation actuator.
INSTALLATION PROCEDURE
1. Install the recirculation actuator.
2. Install the recirculation actuator screws.
NOTE: Refer toFastener Notice in Service Precautions.
Tighten
Tighten the screws to 1.9 N.m (17 lb in).
3. Install the air inlet assembly.
4. Install the screws to the HVAC module assembly.
Tighten
Tighten the screws to 1.9 N.m (17 lb in).
5. Install the HVAC module assembly.
6. Recalibrate the recirculation actuator on vehicles equipped with automatic climate control (C68), See: Testing and Inspection/Programming and