Rainier 2WD V8-5.3L VIN P (2004)
Air Door Actuator / Motor: Service and Repair
Mode Actuator Replacement - Auxiliary
MODE ACTUATOR REPLACEMENT - AUXILIARY
REMOVAL PROCEDURE
1. Remove the right rear quarter trim panel.
2. Disconnect the electrical connector from the mode actuator-auxiliary (1).
3. Remove the mode actuator-auxiliary (1) from the HVAC module-auxiliary.
4. Remove the retaining screws from the mode actuator-auxiliary.
INSTALLATION PROCEDURE
1. Install the mode actuator (1) to the HVAC module-auxiliary.
2. Install the screws to the mode actuator-auxiliary.
NOTE: Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings
Tighten
Tighten the screws to 1.9 N.m (17 lb in).
3. Connect the electrical connector to the mode actuator-auxiliary (1).
4. Install the right rear quarter trim panel.
5. Calibrate the HVAC module actuators, See: Testing and Inspection/Programming and Relearning