Rainier 2WD V8-5.3L VIN P (2004)
Evaporative Emissions Hose: Service and Repair
EVAP Hoses/Pipes Replacement - Engine
EVAPORATIVE EMISSION (EVAP) HOSES/PIPES REPLACEMENT - ENGINE
REMOVAL PROCEDURE
IMPORTANT: Clean the tube connections and surrounding areas before disconnecting in order to avoid possible evaporative emission (EVAP)
system contamination.
1. Disconnect the EVAP tube from the EVAP canister purge solenoid.
-
Push the large size white retainer portion in.
-
Push down, while pulling up slightly in order to disengage the tube.
2. Disconnect the EVAP tube from the chassis EVAP pipe.
-
Push the large size white retainer portion in.
-
Push down, while pulling up slightly in order the disengage the tube.
3. Remove the EVAP tube.
4. Cap the EVAP canister purge solenoid and the EVAP chassis pipe in order to prevent possible EVAP system contamination.
INSTALLATION PROCEDURE
1. Remove the caps from the EVAP canister purge solenoid and the EVAP chassis pipe.
2. Install the EVAP tube.
3. Connect the EVAP tube to the EVAP chassis pipe.
4. Connect the EVAP tube to the EVAP canister purge solenoid.