Rainier 2WD V8-5.3L VIN P (2004)
9. Install the 3 bolts (1) that retain the junction block to the block base.
Tighten the 3 bolts to 3.5 N.m (31 lb in).
10. Install the BCM to the rear electrical center.
11. Install the battery feed terminal nut (2) to the junction block.
Tighten the battery feed terminal nut to 10 N.m (88 lb in).
12. Install the rear electrical center cover.
13. If replacing the rear electrical center on the short wheelbase Ascender, position the left second row seat to a passenger position.
14. If replacing the rear electrical center on the long wheelbase Ascender, install the left second row seat.
15. Connect the battery negative cable.
