Rainier 2WD V8-5.3L VIN P (2004)
^
B1 (circuit 199, brown) and B5 (circuit 116, yellow)
^
A8 (circuit 599, brown) and B3 (circuit 1547, brown)
^
B2 (circuit 46, dark blue) and B6 (circuit 115, light blue)
^
A9 (circuit 546, dark blue) and A1 (circuit 1946, black)
15.
Repin the circuits as follows and then wrap foil tape GM P/N 10184916, around the outside of all 4 twisted pairs ensuring that there are no gaps in
the taping around the twisted wires.
^
B1 (circuit 199, brown) to B6
^
B5 (circuit 116, yellow) to B5 (original location)
^
A8 (circuit 599, brown) to A8 (original location)
^
B3 (circuit 1547, brown) to A9
^
B2 (circuit 46, dark blue) to B2 (original location)
^
B6 (circuit 115, light blue) to B3
^
A9 (circuit 546, dark blue) to B1
^
A1 (circuit 1946, black) to A1 (original location)
Important:
Circuit 199 requires new terminal P/N 15304711 and circuit 115 requires new terminal P/N 12191811.
16.
Ground the foil tape utilizing a 14 gauge wire where one end is contacting the conductive side of the foil tape and the other end is placed in cavity
B8. Use terminal P/N 12191811. Wrap the wire and harness with vinyl electrical tape.
17.
Install the console harness into the console.
18.
Install the rear seat audio module to the console.
19.
On the IP side of connector C307, repin the following circuits.
^
B1 (circuit 199, brown) to B6
^
B3 (circuit 1547, brown) to A9
^
B6 (circuit 115, light blue) to B3
^
A9 (circuit 546, dark blue) to B1
Important:
Circuit 199 (B1) requires new terminal P/N 15304728 and circuit 115 (B6) requires new terminal P/N 15304701.
20.
On the IP side of connector C307, add the remaining ground for the foil tape. Connect one end to ground G102 located in the engine compartment
at the left fender. Place the other end into cavity B8 using terminal P/N 15304701. Route along existing harness and secure with tape.
21.
Install the console floor bracket into the vehicle.
