Rainier 2WD V8-5.3L VIN P (2004)
1. Rem6ve the key from the ignition.
2. Connect the side impact sensor yellow 2-way connector (5) located near the bottom right of the door.
3. Install the CPA (3) to the side impact sensor yellow 2-way connector (5) located near the bottom right of the door.
4. Install the RF door trim panel.
5. Install the SIR fuse to the fuse block (1) located in the underhood fuse block.
6. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
6.1.
The AIR BAG indicator will flash 7 times.
6.2.
The AIR BAG indicator will then turn OFF.
7. Perform the Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.