Rainier 2WD V8-5.3L VIN P (2004)
Camshaft Position Sensor: Service and Repair
CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the intake manifold.
IMPORTANT: Clean the are around the camshaft position (CMP) sensor before removal in order to prevent debris from entering the engine.
2. Remove the CMP sensor bolt.
3. Remove the CMP sensor.
INSTALLATION PROCEDURE
1. Install the CMP sensor.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the CMP sensor bolt.
Tighten
Tighten the bolt to 29 N.m (21 lb ft).
3. Install the intake manifold.