Rainier 2WD V8-5.3L VIN P (2004)
6. Remove the TPA by inserting a small flat-bladed tool into the small slot on the TPA and pushing down until the TPA comes out of the connector.
Gently pry the TPA out of the connector.
7. Insert the J 44020-4 (GM P/N 15314260) tool into the 2 triangular cavities on each side of the terminal at the front of the connector.
8. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a
terminal out of a connector.
TERMINAL REPAIR PROCEDURE
Use the appropriate wire assembly repair kits available through Saturn Service Parts.