Rainier AWD L6-4.2L (2007)
*
When lifting or jacking a vehicle, be certain that the lift pads do not contact the exhaust system, brake pipes, cables, HVAC lines, wiring
harnesses, fuel lines, or underbody. Such contact may result in damage or unsatisfactory vehicle performance.
*
When using a frame-contact hoist, only place the pads on flat surfaces. Do not place pads within 50 mm (2 in) of any radius.
*
Before lifting the vehicle, verify that the vehicle loads are secure and equally distributed.
*
When major components are removed from the vehicle when supported on a hoist, support the vehicle with jack stands at the opposite end from
which the components are being removed and secure the vehicle frame to the hoist pads nearest the component to be removed.
Vehicle Jacking
*
Park the vehicle on a clean, hard, level surface before jacking the vehicle.
*
Any time you lift the vehicle on one end, chock the wheels at the opposite end.
*
Use jack stands in order to provide support.
*
When supporting the vehicle using jack stands, place the jack stands under the side rails or the axle.
*
When lifting under the rear differential, do not allow the jack pad to contact the rear stabilizer bar or mounting hardware.