Rainier AWD L6-4.2L (2007)
Transfer Case Rear Output Shaft Speed Sensor Replacement - Right Side
Transfer Case Rear Output Shaft Speed Sensor Replacement - Right Side
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Disconnect the transfer case right rear speed sensor electrical connector.
3. Remove the transfer case speed sensor.
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the transfer case right rear speed sensor.
Tighten the speed sensor to 17 N.m (13 lb ft).
2. Connect the transfer case right rear speed sensor electrical connector.
3. Lower the vehicle. Refer to Lifting and Jacking the Vehicle.