Rainier AWD L6-4.2L VIN S (2005)
Body / Frame Mount Bushing: Service and Repair
Frame Cushion or Insulator Replacement
Removal Procedure
Properly support the frame when you change the body mounts. If only one mount is changed, lower the entire side on which the mount in placed in order
to provide clearance for the mount.
1. Raise the vehicle slightly on a hoist. Refer to Vehicle Lifting.
2. Place jack stands under the body on the side of the vehicle that the mounts will be placed.
3. Remove the body mount bolt, retainer, and lower cushion (1) from the radiator support.
4. Remove the body mount bolts, retainers, and lower cushions (1) from the 5 other mount locations.
5. Lower the hoist enough in order to leave the body supported by the jack stands.
6. Remove the upper cushions (2) from the vehicle.
Installation Procedure
1. Install the upper cushions (2) to the vehicle.
2. Raise the frame slightly on the hoist.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the lower cushions, retainers, and bolts to the 5 body mount locations.
Tighten the bolts to 80 N.m (59 lb ft).
