Rainier AWD V8-5.3L VIN P (2004)
Seat Cushion: Service and Repair
Seat Cushion Replacement - Rear No. 1 (Short Wheelbase)
SEAT CUSHION REPLACEMENT - REAR NO. 1 (SHORT WHEELBASE)
REMOVAL PROCEDURE
1. Remove the rear seat bracket trim cover.
2. Remove the hydraulic jack from the jack stowage area, on the left side only.
3. Position the seat cushion assembly in order to gain access to the 2 rear seat mounting nuts.
4. Remove the 2 mounting nuts.
5. Remove the seat cushion assembly from the vehicle.
INSTALLATION PROCEDURE
1. Position the seat cushion assembly to the vehicle.
2. Install the 2 nuts that retain the seat cushion assembly to the floor panel.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the rear seat mounting nuts to 45 N.m (33 lb ft).
3. Install the hydraulic jack into the jack stowage area, on the left side only.
4. Adjust the seat cushion assembly to the latched position.
5. Install the rear mount trim cover.
