Reatta V6-231 3.8L VIN C SFI (1990)
mm shim is installed on top of the 5 mm shim, trim the location tab off the bottom of the 10 mm shim before installation. Refer to Figure 1.
5. Check and realign the front and rear suspension as described in Section 3A.
6. Replace upper cradle mounts (1990 vehicles only) at all six locations with the following part number:
Upper Insulator Assembly
03533046
six per vehicle
NOTE:
Reuse cradle spacer, P/N 1626368, and bolt, P/N 1626873, with the above parts as received on the vehicle.
Follow procedures as outlined in Section 10-3 of the 1990 Service Information Manual.
7. Road test to ensure repair procedure has not induced any squeaks or rattles.
NOTE:
1990 Reatta convertible service parts list is as follows:
Insulator Assembly
03533046 (6)
Spacer-Rear Spring
01648853 (2)
Parts are currently available from GMSPO.