Regal L4-2.0L Turbo (2011)
Note:
*
The camshaft actuators should not rotate during the removal or installation.
*
Ensure the tips of the EN-48749 are fully engaged into the timing chain. The retention tool rod can be used on the back side of the chain to
ensure the teeth from the retention tool are engaged.
10. Install the timing chain retention tool EN-48749 (1) to the exhaust side of the timing chain.
11. Remove and discard the exhaust camshaft actuator bolt (2).
12. Remove the exhaust camshaft actuator (3) from the camshaft while also removing the actuator from the timing chain.
Installation Procedure
