Regal L4-2.0L Turbo (2011)
2. Install the transmission mount to bracket through bolt (1) and tighten to 100 Nm (74 lb ft).
3. Install the rear mount to frame fasteners (1, 2) and tighten to 110 Nm (81 lb ft).
4. Perform the Powertrain Mount Balancing - Lower. Refer to the appropriate engine section.
5. Remove the jack stand.
6. Install the left tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
7. Lower the vehicle.
Transmission Mount Replacement - Left Side
Transmission Mount Replacement - Left Side
Removal Procedure
1. Remove the battery box. Refer to Battery Tray Replacement (See: Starting and Charging/Battery/Battery Tray/Service and Repair).
2. Prior to removing the mount, mark mount to transmission, mount to body interfaces and fasteners to mount interfaces using spray paint or a marker