Regal L4-2.0L Turbo (2011)
Constant Velocity Joint Boot: Service and Repair
Front Wheel Drive Shaft Outer Joint and Boot Replacement
Front Wheel Drive Shaft Outer Joint and Boot Replacement
Special Tools
*
CH 48894 - Wheel Drive Shaft Boot Clamp Pliers
*
DT 35910 - Drive Axle Seal Clamp Pliers
For equivalent regional tools, refer to Special Tools (See: Tools and Equipment).
Note: The outer Constant Velocity Joint is not serviced separately. If the CV joint is found to have excessive wear or damage, replace the wheel drive
shaft as an assembly.
Disassemble Procedure
1. Remove the wheel drive shaft from the vehicle.
*
For the left wheel drive shaft, refer to Front Wheel Drive Shaft Replacement - Left Side (GNA) (See: Service and Repair/Front Wheel Drive
Shaft Replacement - Left Side (GNA)).
*
For the right wheel drive shaft, refer to Front Wheel Drive Shaft Replacement - Right Side (GNA) (See: Service and Repair/Front Wheel
Drive Shaft Replacement - Right Side (GNA)).
2. Clamp the drive axle shaft in a soft jawed vice.