Regal V6-173 2.8L (1988)
Knock Sensor: Description and Operation
ESC Knock Sensor
PURPOSE
The knock sensor is mounted on the engine to detect engine detonation and sends an AC signal to the Electronic Control Module (ECM) when it
does detect engine detonation.
OPERATION
The (ECM) will retard the electronic spark timing based on the signal being received from the knock sensor.
The circuitry within the knock sensor causes the ECM 5 volts to be pulled down so that under a no knock condition, circuit 496 would measure
about 2.5 volts. The knock sensor produces an AC signal which rides on the 2.5 volts DC voltage.
The amplitude and signal frequency is dependent upon the knock level. If circuit 496 becomes open or shorted to ground, the voltage will either go
above 3.5 volts or below 1.5 volts. If either of these conditions are met for about 1/2 second, a Code 43 will be stored.
