Regal V6-191 3.1L VIN M SFI (1995)
ABS Brake Modulator/Master Cylinder Assembly Components
Assemble
1. With the brake modulator upside down, and the gears facing you, rotate each ABS brake modulator gear counterclockwise until movement stops.
This procedure will position the pistons on the ABS brake modulator very close to the top of the modulator bore. This will simplify the brake
bleeding procedure.
2. Motor pack to brake modulator assembly.
Important
^
Take care in handling the motor packs. If dropped or damaged during handling the ABS brake motor pack must be replaced.
^
Align each of the three ABS brake motor pack pinions with the brake modulator gears.
3. Four Torx head screws.
Tighten
^
Torx head screws to 4.5 Nm (40 inch lbs.).
4. Gear cover to ABS brake modulator-brake master cylinder assembly.