Regal V6-191 3.1L VIN M SFI (1995)
3. Install the upper intake manifold studs
4. Install the upper intake manifold bolts. Tighten the studs and bolts to 25 Nm (18 ft. lbs.).
Notice: The OEM service manual does not provide a torque sequence for the upper intake manifold.
5. Install the EGR valve. See Powertrain Management.
6. Install the MAP sensor. See Powertrain Management.
7. Install all of the necessary vacuum hoses.
8. Install the electrical connectors to the manifold. See Powertrain Management.
9. Install the generator front and rear braces. See Starting and Charging.
10. Install the ignition coil. See Starting and Charging.
11. Install the electrical connectors to the ignition coil.
12. Rotate the engine.
13. Install the engine mount struts at the engine.
14. Install the power brake booster vacuum hose to the manifold. See Brakes and Traction Control.
15. Install the automatic transaxle vacuum modulator pipe. See Transmission and Drivetrain.
16. Install the thermostat bypass clip nut to the upper intake manifold.
17. Install the accelerator control cable bracket. See Powertrain Management.
18. Install the accelerator control and cruise control cable to the throttle body. See Powertrain Management.
19. Install the air cleaner duct.
20. Connect the negative battery cable. .
