Regal V6-231 3.8L Turbo VIN 7 FI (1986)
PUSHROD/NYLON RETAINER ASSEMBLY
5.
Visually inspect the pushrod socket and remove any particles left from the original rubber retainer. (See Illustration). Denatured alcohol can be
used to clean socket.
6.
Disconnect the original pushrod, retainer, and boot from the brake pedal. Discard the pushrod and retainer. Do not discard the boot.
7.
Insert the new pushrod/nylon retainer assembly into the boot and install the boot onto the bracket.
8.
Attach the new pushrod/retainer assembly to the brake pedal.
9.
Pull the brake pedal rearward as far as it will go and block it from moving forward.
10.
Reinstall the Powermaster unit to the bracket (nut torque should be 20-34 N-m or 15 to 25 ft.lbs.).
11.
Install the pushrod in the Powermaster unit by inserting the pushrod into the socket and carefully applying up to 100 lbs. load to the service brake
pedal.
12.
Reinstall the brake light and cruise control switches and adjust per the Service Manual.
WARRANTY INFORMATION
Labor Operation Number:
T1183
Labor Time:
.4 Hours
Trouble Code:
92