Regal V6-231 3.8L Turbo VIN 9 FI (1984)
FIGURE 2 - 1985 REGAL AND REGAL LIMITED LATE DESIGN REAR BUMPER ATTACHMENT -LEFT SIDE SHOWN
6.
Assemble new reinforcement and rub strip to bumper. Refer to Figure 2.
^
Nine (9) torx head bolts used -
Bottom edge of bumper to reinforcement - (Will require three (3) additional bolts from Parts Department to complete assembly.)
^
Ten (10) round head bolts used - Vertical surface of bumper to reinforcement -
^
Eleven (11) stamped metal nuts to rub strip used.
FULLY SEAT RUB STRIP ATTACHING NUTS -- BUT DO NOT STRIP.
7.
Install bumper assembly onto EA's, placing any removed shims in their original location. Center bumper on vehicle and tighten attaching nuts
to 25 N-m (19 ft.lbs.).
CAMPAIGN IDENTIFICATION LABEL
PART C - CAMPAIGN IDENTIFICATION LABEL
Each vehicle modified in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label."
Each label provides a space to include the five-digit dealer code of the dealer performing the campaign service. This information may be inserted with a
typewriter or ballpoint pen.
Each "Campaign Identification Label" is to be located near the Emission (tune-up) label in an area which will be visible when the vehicle is brought in
for periodic servicing by the owner.
Apply "Campaign Identification Label" only on a clean, dry surface.
DISPOSITION OF REPLACED PARTS
Replaced parts must be held for disposition by Buick contact personnel. Each replaced part must have a claim tag attached showing the repair order and
the VIN of the vehicle from which it was removed.