Regal V6-231 3.8L VIN L SFI (1990)
Figures 1 and 2
NOTICE:
WHEN REMOVING A DOOR TRIM PANEL OR SWITCH PLATE, THE IGNITION SWITCH MUST BE IN THE OFF POSITION. THIS WILL
ELIMINATE THE POSSIBILITY OF SHORTING OUT THE SWITCH IF A SCREWDRIVER, AWL, OR METAL OBJECT IS USED TO REMOVE
THE SWITCH FROM THE HARNESS.
REMOVE OR DISCONNECT
1.
Switch assembly by prying lower clips, using a putty knife, through slot in trim panel at bottom of switch housing.
^
Lift lower part of switch assembly from housing using hand.
2.
Lower clips using a nylon spatula
^
Slide spatula between side of switch assembly and housing, pry loose.
3.
Upper clips
^
Remove from assembly
4.
Connectors
INSTALL OR CONNECT
1.
Connectors
2.
Upper clips to switch assembly
^
Rebend to original shape and slide into position
3.
Switch assembly to trim panel
^
Press into position with hand.
TRIM PANEL