Regal V6-260 4.3L DSL (1985)
the area. To correct dirt in paint conditions use a dirt-nib file
to remove dirt speck (nibs) without disturbing surrounding surface. But whatever the case, always use the simplest possible method to repair an
imperfection.
Figure 4 - Body Identification Plate
Identifying Acrylic Enamel Finishes
Because of the different paint properties discussed in Section 1, there are slightly different steps to be followed when repairing over acrylic enamel
finishes.
Before you begin making repairs, you must determine whether the factory finish is acrylic lacquer or acrylic enamel. To do this, check the body
identification plate on the vehicle (Figure 4) or the Service Parts Label.
For identification of acrylic lacquer paint, the letter "L" or the work "Lacquer" will be used. For the acrylic enamels, the letter "W" or the word "Water"
will designate water-borne acrylic enamel. Also, the letter "E" or the word "Enamel" can be used to designate the paint type as acrylic enamel, solvent
reduced.
DIRT-NIB FILE FABRICATION
Fabrication of Dirt-Nib File
1.
Break vixen file into 1 1/2 inch long lengths. See Figure 5.
2.
Dress off sharp ends.
3.
Place 400 to 500 grit sandpaper on flat surface and draw file in fore-aft motions until file teeth are smooth (a light machine oil hastens the
